While boot partition support with EMMC boot is useful, it is constrained by the size of boot hardware partition itself.
In the case of K3 devices, tispl images can contain OP-TEE images that can substantially vary in size and the u-boot image itself can vary over time as we enable various features.
So use the CSD information in the case of EMMC_BOOT configuration being enabled to pick boot partition or UDA FS mode operation to pick.
If EMMC_BOOT is disabled, then depend on filesystem configuration to pick data from UDA.
Signed-off-by: Nishanth Menon nm@ti.com --- New patch arch/arm/mach-k3/am625_init.c | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/arch/arm/mach-k3/am625_init.c b/arch/arm/mach-k3/am625_init.c index 0e5d44269ebf..ad61030a56fa 100644 --- a/arch/arm/mach-k3/am625_init.c +++ b/arch/arm/mach-k3/am625_init.c @@ -228,7 +228,13 @@ u32 spl_mmc_boot_mode(struct mmc *mmc, const u32 boot_device)
switch (bootmode) { case BOOT_DEVICE_EMMC: +#if CONFIG_IS_ENABLED(SUPPORT_EMMC_BOOT) + return (spl_mmc_emmc_boot_partition(mmc) ? MMCSD_MODE_EMMCBOOT : MMCSD_MODE_FS); +#elif defined(CONFIG_SPL_FS_FAT) || defined(CONFIG_SPL_FS_EXT4) + return MMCSD_MODE_FS; +#else return MMCSD_MODE_EMMCBOOT; +#endif case BOOT_DEVICE_MMC: if (bootmode_cfg & MAIN_DEVSTAT_PRIMARY_MMC_FS_RAW_MASK) return MMCSD_MODE_RAW;