On 01.07.21 06:26, Tony Dinh wrote:
In DM Ethernet, the old "egiga0" name is no longer valid, so replace it with Ethernet PHY name from device tree.
Signed-off-by: Tony Dinh mibodhi@gmail.com
board/zyxel/nsa310s/nsa310s.c | 15 +++++++-------- 1 file changed, 7 insertions(+), 8 deletions(-)
diff --git a/board/zyxel/nsa310s/nsa310s.c b/board/zyxel/nsa310s/nsa310s.c index cd4a7723b1..29aded1910 100644 --- a/board/zyxel/nsa310s/nsa310s.c +++ b/board/zyxel/nsa310s/nsa310s.c @@ -1,5 +1,6 @@ // SPDX-License-Identifier: GPL-2.0+ /*
- Copyright (C) 2021 Tony Dinh mibodhi@gmail.com
AFAIU, just changing a few lines, as this patch does, does not justify to add a copyright notice to this file.
- Copyright (C) 2015
- Gerald Kerma dreagle@doukki.net
- Tony Dinh mibodhi@gmail.com
@@ -81,22 +82,18 @@ int board_init(void) return 0; }
+#define PHY_ADR 1
You should be able to read this PHY address from the device-tree now. No need to define this here again.
Thanks, Stefan
- #ifdef CONFIG_RESET_PHY_R void reset_phy(void) { u16 reg;
- u16 phyaddr;
- char *name = "egiga0";
u16 phyaddr = PHY_ADR;
char *name = "ethernet-controller@72000";
if (miiphy_set_current_dev(name)) return;
- /* read PHY dev address */
- if (miiphy_read(name, 0xee, 0xee, (u16 *) &phyaddr)) {
printf("could not read PHY dev address\n");return;- }
- /* set RGMII delay */ miiphy_write(name, phyaddr, MV88E1318_PGADR_REG, MV88E1318_MAC_CTRL_PG); miiphy_read(name, phyaddr, MV88E1318_MAC_CTRL_REG, ®);
@@ -131,5 +128,7 @@ void reset_phy(void) /* downshift */ miiphy_write(name, phyaddr, 0x10, 0x3860); miiphy_write(name, phyaddr, 0x0, 0x9140);
- printf("MV88E1318 PHY initialized on %s\n", name); } #endif /* CONFIG_RESET_PHY_R */
Viele Grüße, Stefan