From: Paul Kocialkowski contact@paulk.fr
Remove custom config options that are not particularly necessary. Align them with OMAP3 defaults used on other boards (especially for memory locations).
Also enable Thumb build to reduce the SPL size and remove the custom prompt text.
This makes the config a lot more minimalistic, maintainable and easier to read.
Signed-off-by: Paul Kocialkowski contact@paulk.fr --- configs/sniper_defconfig | 16 ++++------------ 1 file changed, 4 insertions(+), 12 deletions(-)
diff --git a/configs/sniper_defconfig b/configs/sniper_defconfig index 08ab3a66c51a..5c6f9328bf8b 100644 --- a/configs/sniper_defconfig +++ b/configs/sniper_defconfig @@ -1,28 +1,20 @@ CONFIG_ARM=y -# CONFIG_SYS_THUMB_BUILD is not set CONFIG_ARCH_OMAP2PLUS=y -CONFIG_TEXT_BASE=0x80100000 -CONFIG_SYS_MALLOC_LEN=0x120000 -CONFIG_SYS_MALLOC_F_LEN=0x400 +CONFIG_SYS_MALLOC_F_LEN=0x4000 CONFIG_TARGET_SNIPER=y -CONFIG_SPL_STACK=0x4020fffc -CONFIG_SPL_BSS_START_ADDR=0x80000000 +CONFIG_SPL_SYS_MALLOC_F_LEN=0x400 CONFIG_SPL=y CONFIG_DISTRO_DEFAULTS=y CONFIG_BOOTCOMMAND="setenv boot_mmc_part ${kernel_mmc_part}; if test reboot-${reboot-mode} = reboot-r; then echo recovery; setenv boot_mmc_part ${recovery_mmc_part}; fi; if test reboot-${reboot-mode} = reboot-b; then echo fastboot; fastboot 0; fi; part start mmc ${boot_mmc_dev} ${boot_mmc_part} boot_mmc_start; part size mmc ${boot_mmc_dev} ${boot_mmc_part} boot_mmc_size; mmc dev ${boot_mmc_dev}; mmc read ${kernel_addr_r} ${boot_mmc_start} ${boot_mmc_size} && bootm ${kernel_addr_r};" -CONFIG_SYS_CBSIZE=512 -CONFIG_SYS_PBSIZE=538 CONFIG_SYS_CONSOLE_IS_IN_ENV=y -# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set +CONFIG_SPL_SYS_MALLOC_SIMPLE=y CONFIG_SPL_SYS_MALLOC=y -CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y -CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x80208000 +CONFIG_SPL_SYS_MALLOC_SIZE=0x800000 # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION=y CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION=2 # CONFIG_SPL_FS_EXT4 is not set # CONFIG_SPL_NAND_SUPPORT is not set -CONFIG_SYS_PROMPT="sniper # " CONFIG_CMD_GPIO=y CONFIG_CMD_I2C=y CONFIG_CMD_MMC=y