On 16/12/2013 23:44, Otavio Salvador wrote:
The macro allows easy setting in per-pin, as for example:
,---- | imx_iomux_v3_setup_pad(MX6_PAD_NANDF_D1__GPIO_2_1 | MUX_MODE_SION); `----
The IOMUX_CONFIG_SION allows for reading PAD value from PSR register.
The following quote from the datasheet:
,---- | ... | 28.4.2.2 GPIO Write Mode | The programming sequence for driving output signals should be as follows: | 1. Configure IOMUX to select GPIO mode (Via IOMUXC), also enable SION if need | to read loopback pad value through PSR | 2. Configure GPIO direction register to output (GPIO_GDIR[GDIR] set to 1b). | 3. Write value to data register (GPIO_DR). | ... `----
This fixes the gpio_get_value to properly work when a GPIO is set for output and has no conflicts.
Thanks for Benoît Thébaudeau benoit.thebaudeau@advansee.com, Fabio Estevam fabio.estevam@freescale.com and Eric Bénard eric@eukrea.com for helping to properly trace this down.
Signed-off-by: Otavio Salvador otavio@ossystems.com.br
Applied to u-boot-imx, thanks !
Best regards, Stefano Babic