Dear Mateusz Kulikowski,
Mateusz Kulikowski mateusz.kulikowski@gmail.com writes:
Add support for USB-A9263 board manufactured by Calao Systems (http://www.calao-systems.com/). Code is based on old U-Boot sources (2010.09) released by Calao.
Signed-off-by: Mateusz Kulikowski mateusz.kulikowski@gmail.com
Changes for v3
- Updated Makefile to a new build system
- Use generic GPIO for NAND and MAC (requires new GPIO patches)
- Use common at91 phy reset
- Dropped spi0 clock setup (pin is unused)
- Fixed PHY address as 0x0001 and dropped PHY autodetect
(no need for autodetect - PHY address is bootstrapped to 1)
board/calao/usb_a9263/Makefile | 14 ++++ board/calao/usb_a9263/usb_a9263.c | 148 +++++++++++++++++++++++++++++++++ boards.cfg | 1 + include/configs/usb_a9263.h | 169 ++++++++++++++++++++++++++++++++++++++ 4 files changed, 332 insertions(+) create mode 100644 board/calao/usb_a9263/Makefile create mode 100644 board/calao/usb_a9263/usb_a9263.c create mode 100644 include/configs/usb_a9263.h
applied to u-boot-atmel/master, thanks!
Best regards, Andreas Bießmann