Dear Scott Wood,
On 07/02/2013 03:57:58 PM, Marek Vasut wrote:
Dear Scott Wood,
On 07/02/2013 10:11:55 AM, Marek Vasut wrote:
The driver triggered a BUG() in nand_base.c:3214/nand_scan_tail() because the ecc.strength was incorrectly set in case of
NAND_ECC_HW
instead of NAND_ECC_HW_SYNDROME ECC mode.
Signed-off-by: Marek Vasut marex@denx.de Cc: Benoît Thébaudeau benoit.thebaudeau@advansee.com Cc: Fabio Estevam fabio.estevam@freescale.com Cc: Scott Wood scottwood@freescale.com
drivers/mtd/nand/mxc_nand.c | 7 ++----- 1 file changed, 2 insertions(+), 5 deletions(-)
diff --git a/drivers/mtd/nand/mxc_nand.c
b/drivers/mtd/nand/mxc_nand.c
index ac435f2..08c7b8b 100644 --- a/drivers/mtd/nand/mxc_nand.c +++ b/drivers/mtd/nand/mxc_nand.c @@ -1238,15 +1238,12 @@ int board_nand_init(struct nand_chip
*this)
this->ecc.write_oob = mxc_nand_write_oob_syndrome; this->ecc.bytes = 9; this->ecc.prepad = 7;
} else {
this->ecc.mode = NAND_ECC_HW;}
if (this->ecc.mode == NAND_ECC_HW) {
if (is_mxc_nfc_1())
this->ecc.strength = 1;else
this->ecc.strength = 4;
} else {
this->ecc.mode = NAND_ECC_HW;}
Where does ecc.strength now get set for the non-SYNDROME case?
Gone ;-) The strength only needs to be set for the SYNDROME case according to the code in nand_base.c .
Read it again. Note the lack of a "break;" before "case NAND_ECC_HW_SYNDROME:".
Blargh. V2-time.
Best regards, Marek Vasut