Enable USB3.0 and SATA phy for zcu102 boards.
Signed-off-by: Michal Simek michal.simek@xilinx.com ---
arch/arm/dts/zynqmp-zcu102-revA.dts | 11 +++++++++++ 1 file changed, 11 insertions(+)
diff --git a/arch/arm/dts/zynqmp-zcu102-revA.dts b/arch/arm/dts/zynqmp-zcu102-revA.dts index a2128ebfd8c8..2e382562c496 100644 --- a/arch/arm/dts/zynqmp-zcu102-revA.dts +++ b/arch/arm/dts/zynqmp-zcu102-revA.dts @@ -14,6 +14,7 @@ #include "zynqmp-clk.dtsi" #include <dt-bindings/gpio/gpio.h> #include <dt-bindings/pinctrl/pinctrl-zynqmp.h> +#include <dt-bindings/phy/phy.h>
/ { model = "ZynqMP ZCU102 RevA"; @@ -884,6 +885,8 @@ drivers/hwmon/pmbus/Makefile:11:obj-$(CONFIG_SENSORS_MAX20751) += max20751.o ceva,p1-comwake-params = /bits/ 8 <0x06 0x14 0x08 0x0E>; ceva,p1-burst-params = /bits/ 8 <0x13 0x08 0x4A 0x06>; ceva,p1-retry-params = /bits/ 16 <0x96A4 0x3FFC>; + phy-names = "sata-phy"; + phys = <&lane3 PHY_TYPE_SATA 1 1 125000000>; };
/* SD1 with level shifter */ @@ -895,6 +898,10 @@ drivers/hwmon/pmbus/Makefile:11:obj-$(CONFIG_SENSORS_MAX20751) += max20751.o xlnx,mio_bank = <1>; };
+&serdes { + status = "okay"; +}; + &uart0 { status = "okay"; pinctrl-names = "default"; @@ -917,6 +924,10 @@ drivers/hwmon/pmbus/Makefile:11:obj-$(CONFIG_SENSORS_MAX20751) += max20751.o &dwc3_0 { status = "okay"; dr_mode = "host"; + snps,usb3_lpm_capable; + phy-names = "usb3-phy"; + phys = <&lane2 PHY_TYPE_USB3 0 2 26000000>; + maximum-speed = "super-speed"; };
&watchdog0 {