On Sunday 20 December 2009 14:30:35 Dirk Behme wrote:
For TI OMAP3 Beagle based Zippy expansion board from TinCanTools [1] I'm currently looking into reusing spi based ENC28J60 network driver
drivers/net/enc28j60.c
It seems to me that it uses LPC2292 specific macros
IO1CLR, IO1SET and IO1DIR
These macros are defined in
asm-arm/arch-lpc2292/lpc2292_registers.h
this is why we didnt bother trying to get this part working on Blackfin boards under u-boot. it works fine for us under Linux, but the u-boot driver is a joke.
From enc28j60.c:
... #define enc_enable() PUT32(IO1CLR, ENC_SPI_SLAVE_CS) #define enc_disable() PUT32(IO1SET, ENC_SPI_SLAVE_CS) ...
... /* configure GPIO */ (*((volatile unsigned long *) IO1DIR)) |= ENC_SPI_SLAVE_CS; (*((volatile unsigned long *) IO1DIR)) |= ENC_RESET;
/* CS and RESET active low */ PUT32 (IO1SET, ENC_SPI_SLAVE_CS); PUT32 (IO1SET, ENC_RESET); ...
Anybody with an idea how to move this code to some (LPC2292?) board specific files to make enc28j60.c more generic to be able to reuse it on other boards?
unless the maintainers of the LPC2292 board are willing to help, i'd say just avoid the issue: - rename/move this driver to indicate it is specific to LPC2292 - create a new driver based on the old one using the common SPI framework
once it starts using the common SPI framework, i should be able to easily help with testing on Blackfin boards. we have a little addon card that lets us hook it up to a bunch of different boards. -mike