Hi Anatolij,
On Tue, Oct 22, 2019 at 5:35 AM Anatolij Gustschin agust@denx.de wrote:
Add support for i.MX8X based Capricorn Giedi SoM.
Supported interfaces: GPIO, ENET, eMMC, I2C, UART.
Console output:
U-Boot SPL 2019.10-00178-g6e34009eee (Oct 21 2019 - 18:16:42 +0200) Trying to boot from MMC1 Load image from MMC/SD 0x3e000
U-Boot 2019.10-00178-g6e34009eee (Oct 21 2019 - 18:16:42 +0200) ##v01.07
CPU: NXP i.MX8QXP RevB A35 at 1200 MHz at 24C
Model: Siemens Giedi Board: Capricorn Build: SCFW 65afe5f6, SECO-FW 9d71fd5b, ATF d6451cc Boot: MMC0 DRAM: 1022 MiB MMC: FSL_SDHC: 0 Loading Environment from MMC... OK In: serial@5a080000 Out: serial@5a080000 Err: serial@5a080000 Net: eth1: ethernet@5b050000 [PRIME] Autobooting in 1 seconds, press "<Esc><Esc>" to stop
Signed-off-by: Anatolij Gustschin agust@denx.de
I am getting a hang on my i.MX8QXP MEK with mainline even if applying your I2C ipg clock patches:
U-Boot SPL 2020.01-00169-g7f2ff3059d-dirty (Jan 07 2020 - 14:50:41 -0300) Normal Boot WDT: Not found! Trying to boot from MMC2_2 Load image from MMC/SD 0x46c00
U-Boot 2020.01-00169-g7f2ff3059d-dirty (Jan 07 2020 - 14:50:41 -0300)
CPU: NXP i.MX8QXP RevB A35 at 1200 MHz at 31C
Model: Freescale i.MX8QXP MEK Board: iMX8QXP MEK Boot: SD1 DRAM: 3 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 Loading Environment from MMC... *** Warning - bad CRC, using default environment
In: serial@5a060000 Out: serial@5a060000 Err: serial@5a060000 Net: Error: ethernet@5b040000 address not set.
(It hangs here)
Where did you get the AT-F, imx-sc-firmware, imx-seco from?
I used these components from 4.19.35 NXP BSP release.
Thanks