Notify AVS driver upon setting clock rate so that voltage is changed accordingly.
Signed-off-by: Keerthy j-keerthy@ti.com --- Changes in v3:
* No change
Changes in v2:
* No change
drivers/clk/clk-ti-sci.c | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/drivers/clk/clk-ti-sci.c b/drivers/clk/clk-ti-sci.c index c25415d410..478349f22f 100644 --- a/drivers/clk/clk-ti-sci.c +++ b/drivers/clk/clk-ti-sci.c @@ -13,6 +13,7 @@ #include <errno.h> #include <clk-uclass.h> #include <linux/soc/ti/ti_sci_protocol.h> +#include <k3-avs.h>
/** * struct ti_sci_clk_data - clock controller information structure @@ -101,6 +102,10 @@ static ulong ti_sci_clk_set_rate(struct clk *clk, ulong rate)
debug("%s(clk=%p, rate=%lu)\n", __func__, clk, rate);
+#ifdef CONFIG_K3_AVS0 + k3_avs_notify_freq(clk->id, clk->data, rate); +#endif + /* Ask for exact frequency by using same value for min/target/max */ ret = cops->set_freq(sci, clk->id, clk->data, rate, rate, rate); if (ret)