On Wed, Aug 22, 2012 at 12:19:03PM -0700, Tom Rini wrote:
On Wed, Aug 22, 2012 at 10:46:19AM -0700, Tom Rini wrote:
On Wed, Aug 22, 2012 at 12:04:27PM +0200, Christian Riesch wrote:
Hi Tom,
On Mon, Aug 20, 2012 at 6:45 PM, Tom Rini trini@ti.com wrote:
- Convert the non-relocation part of board_init_f to spl_board_init, turn on CONFIG_SPL_BOARD_INIT in the configs.
- Remove duplicated code.
- Add spl_boot_device() that returns the statically chosen boot device.
I tested the patchset on the LogicPD AM1808 experimenter's kit:
make da850evm and flashing to SPI flash with mono sfh_OMAP-L138.exe -targetType AM1808 -p /dev/ttyUSB0 -flash_noubl u-boot.ais
Confirmed, and I'll update the README to say that is how you can write the u-boot.ais in recovery mode.
The board boots up fine, but after pressing the reset button or issuing the u-boot "reset" command, it is dead. Only power-cycling helps. Before enabling the SPL framework in this patch reset works fine. Any ideas?
OK, I don't like the SPL malloc fix from before and I think it just masked, partially, a real problem. The SPI code did not change in the
OK, I get what that fixes now, oops. But still, something is going on here, debugging more.
OK, got it, and a v3 shortly. In short, using CONFIG_SPL_BOARD_INIT as the hook for doing our low-level init isn't completely sufficient, so I've reworked things a little more and tossed in another hook point. Now I'm also seeing the initial console output I had been missing.