There are many musb prints in SPL and U-Boot log. These prints are required only during musb debug. So replacing printk with pr_debug in musb_core.
Signed-off-by: Lokesh Vutla lokeshvutla@ti.com --- drivers/usb/musb-new/musb_core.c | 20 ++++++++------------ 1 file changed, 8 insertions(+), 12 deletions(-)
diff --git a/drivers/usb/musb-new/musb_core.c b/drivers/usb/musb-new/musb_core.c index da93571..36681b6 100644 --- a/drivers/usb/musb-new/musb_core.c +++ b/drivers/usb/musb-new/musb_core.c @@ -1311,9 +1311,7 @@ static int __devinit ep_config_from_table(struct musb *musb) break; }
- printk(KERN_DEBUG "%s: setup fifo_mode %d\n", - musb_driver_name, fifo_mode); - + pr_debug("%s: setup fifo_mode %d\n", musb_driver_name, fifo_mode);
done: offset = fifo_setup(musb, hw_ep, &ep0_cfg, 0); @@ -1341,10 +1339,9 @@ done: musb->nr_endpoints = max(epn, musb->nr_endpoints); }
- printk(KERN_DEBUG "%s: %d/%d max ep, %d/%d memory\n", - musb_driver_name, - n + 1, musb->config->num_eps * 2 - 1, - offset, (1 << (musb->config->ram_bits + 2))); + pr_debug("%s: %d/%d max ep, %d/%d memory\n", musb_driver_name, n + 1, + musb->config->num_eps * 2 - 1, offset, + (1 << (musb->config->ram_bits + 2)));
if (!musb->bulk_ep) { pr_debug("%s: missing bulk\n", musb_driver_name); @@ -1447,8 +1444,7 @@ static int __devinit musb_core_init(u16 musb_type, struct musb *musb) if (reg & MUSB_CONFIGDATA_SOFTCONE) strcat(aInfo, ", SoftConn");
- printk(KERN_DEBUG "%s: ConfigData=0x%02x (%s)\n", - musb_driver_name, reg, aInfo); + pr_debug("%s:ConfigData=0x%02x (%s)\n", musb_driver_name, reg, aInfo);
aDate[0] = 0; if (MUSB_CONTROLLER_MHDRC == musb_type) { @@ -1469,8 +1465,8 @@ static int __devinit musb_core_init(u16 musb_type, struct musb *musb) snprintf(aRevision, 32, "%d.%d%s", MUSB_HWVERS_MAJOR(musb->hwvers), MUSB_HWVERS_MINOR(musb->hwvers), (musb->hwvers & MUSB_HWVERS_RC) ? "RC" : ""); - printk(KERN_DEBUG "%s: %sHDRC RTL version %s %s\n", - musb_driver_name, type, aRevision, aDate); + pr_debug("%s: %sHDRC RTL version %s %s\n", musb_driver_name, type, + aRevision, aDate);
/* configure ep0 */ musb_configure_ep0(musb); @@ -2122,7 +2118,7 @@ musb_init_controller(struct musb_hdrc_platform_data *plat, struct device *dev,
pm_runtime_put(musb->controller);
- dev_info(dev, "USB %s mode controller at %p using %s, IRQ %d\n", + pr_debug("USB %s mode controller at %p using %s, IRQ %d\n", ({char *s; switch (musb->board_mode) { case MUSB_HOST: s = "Host"; break;