On 6/29/2018 9:52 AM, Marek Vasut wrote:
On 06/29/2018 04:44 PM, Jason Rush wrote:
On 6/29/2018 9:34 AM, Marek Vasut wrote:
On 06/29/2018 04:31 PM, Jason Rush wrote:
Dinh,
Hi,
A while ago, you posted the following patchset for SoCFPGA to add the PL330 DMA driver, and updated the SoCFPGA SDRAM init to write zeros to SDRAM to initialize the ECC bits if ECC was enabled:
https://lists.denx.de/pipermail/u-boot/2016-October/269643.html
I know it's been a long time, so I'll summarize some of the conversation...
At the time, you had a problem with the patchset causing the SPL to fail to find the MMC. You had tracked it down to an issue with the following commit "a78cd8613204 ARM: Rework and correct barrier definitions". You and Marek discussed it a bit, but I don't think there was a real conclusion. You submitted a second version of the patchset asking for advice on debugging the issue:
https://lists.denx.de/pipermail/u-boot/2016-December/275822.html
No real conversation came from the second patchset, and that was the end of the patch.
I was hoping we could revisit adding your patchset again. I am working on a custom SoCFPGA board with a Cyclone V and ECC SDRAM. I rebased your patchset against v2018.05 and it is working on my custom board (although I don't have an MMC). I also tested it on a SoCKit booting from an MMC (I forced it to scrub the SDRAM on the SoCKit, because it doesn't have ECC RAM), and the SoCKit finds the MMC and boots.
I don't have any suggestions on why it is working now on my board and not back when you first submitted the patchset. Maybe something else was fixed in the MMC? I was hoping you and Marek could test this patch again on some different SoCFPGA boards to see if you get the same results.
Look at this patch http://git.denx.de/?p=u-boot/u-boot-socfpga.git;a=commit;h=9bb8a249b292d26f1...
You likely want similar approach, it's faster then the DMA and much simpler.
Thanks Marek. I'll give it a try. Would you be interested in a similar patch for the Gen 5?
I don't have any Gen5 board which uses ECC, do you ? If so, yes, prepare a patch, it should be very similar.
Make sure to measure how long it takes to scrub the memory and how much memory you have, I'd be interested in the numbers.
Looking at the master branch, it doesn't look like that code is ever being called? The sdram_init_ecc_bits() function is called from the ddr_calibration_sequence function(), but I can't find where ddr_calibration_sequence is called().
Either way, I can test it. I have a custom Cyclone V board with ECC, and the Intel Arria V SoC Dev Kit I can test it on too which I think has ECC.