Hi Simon,
On Sun, Nov 20, 2016 at 4:25 AM, Simon Glass sjg@chromium.org wrote:
At present all 16/32-bit init is controlled by CONFIG_X86_RESET_VECTOR. If this is enabled, then U-Boot is the 'first' boot loader and handles execution from the reset vector through to U-Boot's command prompt. If it is not enabled then U-Boot starts at the 32-bit entry and skips most of its init, assuming that the previous boot loader has done this already.
With the move to suport 64-bit operation, we have more cases to consider. The 16-bit and 32-bit init may be in SPL rather than in U-Boot proper.
Add Kconfig options which control the location of the 16-bit and the 32-bit init. These are not intended to be user-setting except for experimentation. Their values should be determined by whether 64-bit U-Boot is used.
Signed-off-by: Simon Glass sjg@chromium.org
Changes in v2: None
arch/x86/Kconfig | 39 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 39 insertions(+)
diff --git a/arch/x86/Kconfig b/arch/x86/Kconfig index 5db8f13..e57362e 100644 --- a/arch/x86/Kconfig +++ b/arch/x86/Kconfig @@ -135,6 +135,45 @@ config X86_RESET_VECTOR bool default n
+# The following options control where the 16-bit and 32-bit init lies +# If SPL is enabled then it normally holds this init code, and U-Boot proper +# is normally a 64-bit build. +# +# The 16-bit init refers to the reset vector and the small amount of code to +# get the processor into 32-bit mode. It may be in SPL or in U-Boot proper, +# or missing altogether if U-Boot is started from EFI or coreboot. +# +# The 32-bit init refers to processor init, running binary blobs including +# FSP, setting up interrupts and anything else that needs to be done in +# 32-bit code. It is normally in the same place as 32-bit init.
in the same place as "16-bit" init?
+config X86_16BIT_INIT
booldepends on X86_RESET_VECTORdefault y if X86_RESET_VECTOR && !SPLhelpThis is enabled when 16-bit init is in U-Boot proper+config SPL_X86_16BIT_INIT
booldepends on X86_RESET_VECTORdefault y if X86_RESET_VECTOR && SPLhelpThis is enabled when 16-bit init is in SPL+config X86_32BIT_INIT
booldepends on X86_RESET_VECTORdefault y if X86_RESET_VECTOR && !SPLhelpThis is enabled when 32-bit init is in U-Boot proper+config SPL_X86_32BIT_INIT
booldepends on X86_RESET_VECTORdefault y if X86_RESET_VECTOR && SPLhelpThis is enabled when 32-bit init is in SPLconfig RESET_SEG_START hex depends on X86_RESET_VECTOR --
Reviewed-by: Bin Meng bmeng.cn@gmail.com
Regards, Bin