Hi Heiko,
On Wed, Jan 8, 2020 at 2:41 AM Heiko Schocher hs@denx.de wrote:
Looking into git history, there is a commit from you:
commit 5b858582512883b8a85d74e108873f9beed1e954 Author: Fabio Estevam festevam@gmail.com Date: Wed Jun 12 12:34:40 2019 -0300
wandboard: Add FIT image support After the transition to DM, only the mx6dl/solo wandboard is supported. Add FIT image support so that all the wandboard variants can be supported, like it was prior to the DM conversion. Successfully booted Linux on mx6q/solo/qp wandboards.So it worked for you? I flashed the u-boot-fit-dtb.bin instead of u-boot-dtb.bin, but this leads to:
Just tested the latest u-boot-imx, which contains the PMIC fix and booting a imx6qp-wandboard-revd1 works fine: http://code.bulix.org/pncucj-1073321
This is the only revd1 wandboard I have access to.
I flashed the SD card as per the board/wandboard/README instructions.
Ethernet is also functional in U-Boot.
The support for imx6q-wandboard-revd1 and imx6dl-wandboard-revd1 still needs to be added (it used to work prior to the DM conversion as you noticed), but unfortunately I don't have access to these variants.
Regards,
Fabio Estevam
resetting ...
U-Boot SPL 2020.01-tbot-00271-gd8a3f52 (Jan 08 2020 - 06:25:09 +0100) Trying to boot from MMC1 mmc_load_image_raw_sector: mmc block read error spl: ext4fs_open failed spl_load_image_ext: error reading image u-boot-dtb.img, err - -1 SPL: failed to boot from all boot devices ### ERROR ### Please RESET the board ###
Same with u-boot-with-spl.imx flashed.
I am sure I make here something wrong... any ideas?
Attached also a working bootlog with an older version [1].
Thanks!
bye, Heiko
[1] working U-Boot bootlog: U-Boot SPL 2019.04-rc4-tbot-00111-gab8fc41 (Jan 08 2020 - 06:18:50 +0100) Trying to boot from MMC1
U-Boot 2019.04-rc4-tbot-00111-gab8fc41 (Jan 08 2020 - 06:18:50 +0100)
CPU: Freescale i.MX6DL rev1.3 at 792 MHz Reset cause: WDOG I2C: ready DRAM: 1 GiB PMIC: PFUZE100 ID=0x10 MMC: FSL_SDHC: 0, FSL_SDHC: 1 Loading Environment from MMC... OK No panel detected: default to HDMI Display: HDMI (1024x768) In: serial Out: serial Err: serial Board: Wandboard rev D1 Net: FEC [PRIME] Hit any key to stop autoboot: 0 =>
-- DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-52 Fax: +49-8142-66989-80 Email: hs@denx.de