Hi Codrin,
On Tue, Jun 30, 2015 at 9:02 AM, Codrin Constantin Ciubotariu codrin.ciubotariu@freescale.com wrote:
Hi Joe,
-----Original Message----- From: Joe Hershberger [mailto:joe.hershberger@gmail.com] Sent: Friday, June 26, 2015 1:41 AM To: Ciubotariu Codrin Constantin-B43658 Cc: u-boot; Joe Hershberger; Sun York-R58495 Subject: Re: [U-Boot] [PATCH 08/11 v2] drivers/net/vsc9953: Add VLAN commands for VSC9953
@@ -270,6 +270,31 @@ static void vsc9953_port_vlan_pvid_set(int port_no, int
pvid)
field_set(pvid,CONFIG_VSC9953_PORT_VLAN_CFG_VID_MASK));
}
+#ifdef CONFIG_VSC9953_CMD
Why does this need to be defined outside of the #ifdef already at the bottom of the file?
I added it here so that vsc9953_port_vlan_pvid_get() could be next to its pair, vsc9953_port_vlan_pvid_set(). If you think that it should be at the bottom of the file I can move it.
OK, I think that makes sense the way you had it. Also, it wouldn't make sense to move out of drivers/net/vsc9953.c, so leave it here.
/* Administrative down */if ((!vsc9953_l2sw.port[port_nr].enabled)) {Why do you have double "((" and "))"?
By mistake, I will remove one pair.
+#ifdef CONFIG_VSC9953_CMD
Why does this need to be defined outside of the #ifdef already at the bottom of the file?
I did this so that similar get/set() functions to be close to one another. Also, the functions guarded by CONFIG_VSC9953_CMD are used only when the ethsw commands are enabled (CONFIG_VSC9953_CMD defined). If a user decides to use the driver for VSC9953, with the switch working in unmanaged state and he doesn't need the commands to configure the switch, he could compile u-boot with CONFIG_VSC9953_CMD undefined. In this case, some warnings will appear at compile time suggesting that functions like vsc9953_port_vlan_egr_untag_get() are defined but not used.
Sounds good. You can leave this here.
Thanks, -Joe