Hi Jorge,
On 5/12/21 11:21 PM, Jorge Ramirez-Ortiz, Foundries wrote:
Hi Michal
We are doing some work on an MPSoC UZ3EG platform part of which requires us to replace FSBL with SPL.
Just for curiosity what's the reason for this requirement that fsbl is not enough?
It seems the actual boot process is becoming an issue on these SoCs; currently, 1) we embed the PMU firmware on SPL so the bootrom can extract it and program it;
Actually it is not working like this. PMU FW is own part of boot.bin and it is not embed in SPL.
- then SPL configures the PMU using a
platform specific binary that gets built also with SPL;
PMU cfg object.
and finally,
- SPL sets up the DDR using its psu_init_gpl.c settings (also board
specific, part of the XSA).
yes.
It is this final step in the boot sequence that is being broken by the Dynamic DDR DIMM configuration feature [1]
This was developed for zcu102 and maybe others boards which have DIMM modules where origin part were EOL.
Are you aware of any work in progress to support this? Any thoughts on how to work around it and train the DDR? will the functionality required to implmenet Dynamic DDR DIMM configuration be added as a separate file to the XSA tarball or will we need to do some native implementation in SPL?
I am not aware about any work on SPL side to support this. IIRC FSBL didn't have generic DDR configuration. It was only by reading SPD and aligned some parameters but it is quite a long time I have looked at it last time.
Becase without a change in the last link in the process chain described earlier (calls to psu_init()), DDR just wont be accessible to U-BOOT or OP-TEE.
In our case, we were able to boot from QSPI, boot SPL (in OCM), have SPL unpack and validate the FIT image, execute TF-A(in OCM), but then any jumps to OP-TEE or U-BOOT would obviously not progress since the DDR wasnt properly trained/initialized.
so, any thoughts or plans you can share?
The question is why you need this feature to be there. It is not working for every DIMM module. And normally if you have custom boards you need just one DDR configuration (or limited number based on HW versions) and for that there is really no need to waste your boot up time on it. You can add multiple configurations to psu_init_gpl() and based on any information (board rev/pins/etc) decided which one should be used.
Thanks, Michal