In message 409C0053.1050306@iti.fi you wrote:
Because you did not enter a "go" command, or used a bad address with the "go" ?
Of cource i entered go command and and user right address
This is not obvious. You didn;t mention it in your report, and it didn't work, so there was a chance ther eis an error here.
Why that? Why don't you just use the BDI2000 to load and program the image to flash?
Few reasons, at first, the board is not Icecube, it is my own and it has diferent flash etc.
This is not a reason at all. Of course the BDi2000 can program your flash as well.
It is easiest to do initial testing to load code to internal sram . With
This is something between a matter of taste and an urban legend.
test ethernet, serial, flash and sdram. And it is fast to program flash directly over ethernet.
It's also fast to program flash with the BDI2000.
In either case nothing appears in to the console. Also, allways the address is same and i got the step timeout.
Did you contact Abatron support? What did they say (except for: check for hardware problems - which I'd say, too).
with bdi2000. There is something that i did wrong with bdi2000 configuration and i try figure out what.
Which differences are between your board and the LITE5200?
Best regards,
Wolfgang Denk