Hello Nikita,
Am 28.11.2013 17:04, schrieb Nikita Kiryanov:
Writing zero into I2Ci.I2C_CNT register causes random I2C failures in OMAP3 based devices. This seems to be related to the following advisory which apears in multiple erratas for OMAP3 SoCs (OMAP35xx, DM37xx), as well as OMAP4430 TRM:
Advisory: I2C Module Does Not Allow 0-Byte Data Requests Details: When configured as the master, the I2C module does not allow 0-byte data transfers. Note: Programming I2Ci.I2C_CNT[15:0]: DCOUNT = 0 will cause undefined behavior. Workaround(s): No workaround. Do not use 0-byte data requests.
The writes in question are unnecessary from a functional point of view. Most of them are done after I/O has finished, and the only one that preceds I/O (in i2c_probe()) is also unnecessary because a stop bit is sent before actual data transmission takes place.
Therefore, remove all writes that zero the cnt register.
Cc: Heiko Schocherhs@denx.de Cc: Thomas Petazzonithomas.petazzoni@free-electrons.com Cc: Tom Rinitrini@ti.com Cc: Lubomir Popovlpopov@mm-sol.com Cc: Enric Balletbo Serraeballetbo@gmail.com Signed-off-by: Nikita Kiryanovnikita@compulab.co.il Tested-by: Thomas Petazzonithomas.petazzoni@free-electrons.com Tested-by: Lubomir Popovlpopov@mm-sol.com
Changes in V2: Removed all instances of writew(0,&i2c_base->cnt) instead of just the one in i2c_write (following a test of V1 by Thomas Petazzoni).
drivers/i2c/omap24xx_i2c.c | 6 ------ 1 file changed, 6 deletions(-)
Thanks! Applied to u-boot-i2c.git.
bye, Heiko