Re: [PATCH 00/18] arm: k3-am64: Add initial support for AM64 SK

On 06/05/21 4:44 pm, Lokesh Vutla wrote:

AM642 StarterKit (SK) board is a low cost, small form factor board designed for TI’s AM642 SoC. It supports the following interfaces:

• 2 GB LPDDR4 RAM
• x2 Gigabit Ethernet interfaces capable of working in switch and MAC mode
• x1 USB 3.0 Type-A port
• x1 UHS-1 capable µSD card slot
• 2.4/5 GHz WLAN + Bluetooth 4.2 through WL1837
• 512 Mbit OSPI flash
• x2 UART through UART-USB bridge
• XDS110 for onboard JTAG debug using USB
• Temperature sensors, user push buttons and LEDs
• 40-pin Raspberry Pi compatible GPIO header
• 24-pin header for peripherals in MCU island (I2C, UART, SPI, IO)
• 54-pin header for Programmable Realtime Unit (PRU) IO pins
• Interface for remote automation. Includes:
  • power measurement and reset control
  • boot mode change

This series adds support for:

• AM64 SoC detection
• AM64 board detection
• AM64 SK initial support
• Re-use EVM defconfigs for SK.

This series depends on the following series:

• https://patchwork.ozlabs.org/user/todo/uboot/?series=240546
• https://patchwork.ozlabs.org/user/todo/uboot/?series=241946
• https://patchwork.ozlabs.org/user/todo/uboot/?series=242110

Fixed the timer clock frequency locally and applied to u-boot-ti/for-rc

Thanks and regards, Lokesh