Hi Patrick,
On Thu, 12 Sept 2024 at 00:31, Patrick Rudolph patrick.rudolph@9elements.com wrote:
On Thu, Sep 12, 2024 at 2:58 AM Simon Glass sjg@chromium.org wrote:
Hi Patrick,
On Wed, 11 Sept 2024 at 00:25, Patrick Rudolph patrick.rudolph@9elements.com wrote:
Fill the MADT table in the GIC driver and armv8 CPU driver to drop SoC specific code. While the GIC only needs devicetree data, the CPU driver needs additional information stored in the cpu_plat struct.
While on it update the only board making use of the existing drivers and writing ACPI MADT in mainboard code.
TEST: Booted on QEMU sbsa using driver model generated MADT. Signed-off-by: Patrick Rudolph patrick.rudolph@9elements.com Cc: Simon Glass sjg@chromium.org
arch/arm/lib/acpi_table.c | 1 + arch/arm/lib/gic-v3-its.c | 89 ++++++++++++++++++++++++++++++++++++++- drivers/cpu/armv8_cpu.c | 27 ++++++++++++ include/cpu.h | 27 +++++++++++- 4 files changed, 141 insertions(+), 3 deletions(-)
Reviewed-by: Simon Glass sjg@chromium.org
Are the GIC values available by probing, or are they just 'known', and dependent on the compatible string?
Sorry I don't get that question.
The "arm_gic_v3_its" and "arm_gic_v3" driver uses existing DT properties and should work with all existing boards.
The madt_gicc entries are board specific. Besides the mpidr all of them can be 0. Those entries currently do not have matching DT properties in the CPU node that could be used. Some of those entries are present in the GIC node, but there's no direct association between CPU nodes and GIC nodes.
If they are board-specific then they should depend on the board compatible-string, assuming they cannot be read from the devicetree. The properties should be set in the driver, though.
This might be the sort of situation where the GIC binding leaves out stuff and Linux fills it in from internal data? Or perhaps Linux just doesn't care about these features of the GIC?
Regards, Simon