On 5/24/22 07:56, Chin-Ting Kuo wrote:
When SPI_NOR_4B_OPCODES flag is set for a specific flash in spi_nor_ids[] table, EN4B command will not be issued and 4-byte dedicated commands will be used to access SPI flash. Thus, instead of EN4B command, address length is more suitable for deciding whether the controller should be set to 4-byte mode.
Signed-off-by: Chin-Ting Kuo chin-ting_kuo@aspeedtech.com
drivers/spi/spi-aspeed.c | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/drivers/spi/spi-aspeed.c b/drivers/spi/spi-aspeed.c index e5e348eb7b..687ddc370b 100644 --- a/drivers/spi/spi-aspeed.c +++ b/drivers/spi/spi-aspeed.c @@ -504,10 +504,6 @@ static int aspeed_spi_exec_op_user_mode(struct spi_slave *slave, /* Restore controller setting. */ writel(flash->ce_ctrl_read, ctrl_reg);
- /* Set controller to 4-byte mode when flash is in 4-byte mode. */
- if (op->cmd.opcode == SPINOR_OP_EN4B)
priv->info->set_4byte(bus, cs);- return 0; }
This should be part of the patch adding the driver.
Thanks,
C.
@@ -561,6 +557,9 @@ static int aspeed_spi_dirmap_create(struct spi_mem_dirmap_desc *desc) plat->ctrl_base + REG_CE0_CTRL_REG + cs * 4); priv->flashes[cs].ce_ctrl_read = reg_val;
if (op_tmpl.addr.nbytes == 4)priv->info->set_4byte(bus, cs);- dev_dbg(dev, "read bus width: %d [0x%08x]\n", op_tmpl.data.buswidth, priv->flashes[cs].ce_ctrl_read); } else {