-----Original Message----- From: Holger Brunck [mailto:holger.brunck@keymile.com] Sent: Wednesday, June 15, 2011 8:12 PM To: u-boot@lists.denx.de Cc: Valentin Longchamp; Holger Brunck; Prafulla Wadaskar; Heiko Schocher Subject: [PATCH v3 5/5] arm/km: add support for portl2 board
From: Valentin Longchamp valentin.longchamp@keymile.com
This adds support for the keymile Kirkwood BEC portl2 board. This board relies on the km_arm (km_kirkwood) BEC.
The egiga driver is configured for a 100M full-duplex, A/N off connnection to the backplane. This board has always ethernet present, because it is connected to the marvell switch similar to mgcoge3un. The reset_phy functionality is also the same to mgcoge3un.
Signed-off-by: Valentin Longchamp valentin.longchamp@keymile.com Signed-off-by: Holger Brunck holger.brunck@keymile.com cc: Prafulla Wadaskar prafulla@marvell.com cc: Heiko Schocher hs@denx.de
Changes for v3:
- rebase
Changes for v2:
- add this board support patch to the end of the serie
MAINTAINERS | 1 + MAKEALL | 1 + board/keymile/km_arm/km_arm.c | 8 +++-- boards.cfg | 1 + include/configs/portl2.h | 81 +++++++++++++++++++++++++++++++++++++++++ 5 files changed, 89 insertions(+), 3 deletions(-) create mode 100644 include/configs/portl2.h
Applied this patch series 1/5-to-5/5 to u-boot-marvell.git next branch
Regards.. Prafulla . .