Hi,
On 28/01/21 01:36PM, tkuw584924@gmail.com wrote:
From: Takahiro Kuwano Takahiro.Kuwano@infineon.com
Some of Spansion/Cypress chips support volatile version of configuration registers and it is recommended to update volatile registers in the field application due to a risk of the non-volatile registers corruption by power interrupt. This patch adds a function to set Quad Enable bit in CFR1 volatile.
Signed-off-by: Takahiro Kuwano Takahiro.Kuwano@infineon.com
drivers/mtd/spi/spi-nor-core.c | 53 ++++++++++++++++++++++++++++++++++ 1 file changed, 53 insertions(+)
diff --git a/drivers/mtd/spi/spi-nor-core.c b/drivers/mtd/spi/spi-nor-core.c index 2803536ed5..624e730524 100644 --- a/drivers/mtd/spi/spi-nor-core.c +++ b/drivers/mtd/spi/spi-nor-core.c @@ -1576,6 +1576,59 @@ static int spansion_read_cr_quad_enable(struct spi_nor *nor) return 0; }
+/**
- spansion_quad_enable_volatile() - enable Quad I/O mode in volatile register.
- @nor: pointer to a 'struct spi_nor'
- @addr_base: base address of register (can be >0 in multi-die parts)
- @dummy: number of dummy cycles for register read
- It is recommended to update volatile registers in the field application due
- to a risk of the non-volatile registers corruption by power interrupt. This
- function sets Quad Enable bit in CFR1 volatile.
- Return: 0 on success, -errno otherwise.
- */
+static int spansion_quad_enable_volatile(struct spi_nor *nor, u32 addr_base,
u8 dummy)+{
- u32 addr = addr_base | SPINOR_REG_ADDR_CFR1V;
Why do you OR the register offset with the base? Shouldn't you be adding to it?
- u8 cr;
- int ret;
- /* Check current Quad Enable bit value. */
- ret = spansion_read_any_reg(nor, addr, dummy, &cr);
- if (ret < 0) {
dev_dbg(nor->dev,"error while reading configuration register\n");return -EINVAL;- }
- if (cr & CR_QUAD_EN_SPAN)
return 0;- cr |= CR_QUAD_EN_SPAN;
- write_enable(nor);
- ret = spansion_write_any_reg(nor, addr, cr);
- if (ret < 0) {
dev_dbg(nor->dev,"error while writing configuration register\n");return -EINVAL;- }
- /* Read back and check it. */
- ret = spansion_read_any_reg(nor, addr, dummy, &cr);
- if (ret || !(cr & CR_QUAD_EN_SPAN)) {
dev_dbg(nor->dev, "Spansion Quad bit not set\n");return -EINVAL;- }
- return 0;
+}
Rest of the patch LGTM.
#if CONFIG_IS_ENABLED(SPI_FLASH_SFDP_SUPPORT) /**
- spansion_no_read_cr_quad_enable() - set QE bit in Configuration Register.
-- 2.25.1