From: T Karthik Reddy t.karthik.reddy@xilinx.com
As per SD spec when SD host controller is reset, it takes 1000msec to detect the card state. In case, if we enable the sd bus voltage & card detect state is not stable, then host controller will disable the sd bus voltage.
In case of warm/subsystem reboot, due to unstable card detect state host controller is disabling the sd bus voltage to sd card causing sd card timeout error. So we wait for a maximum of 1000msec to get the card detect state stable before we enable the sd bus voltage.
This current fix is workaround for now, this needs to be analysed further. Zynqmp platform should behave the same as Versal, but we did not encounter this issue as of now. So we are fixing it for Versal only.
Signed-off-by: T Karthik Reddy t.karthik.reddy@xilinx.com Signed-off-by: Ashok Reddy Soma ashok.reddy.soma@xilinx.com ---
(no changes since v2)
Changes in v2: - Changed return error from -EIO to -ETIMEDOUT in arasan_sdhci_probe() in card detect state stable workaround
drivers/mmc/zynq_sdhci.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)
diff --git a/drivers/mmc/zynq_sdhci.c b/drivers/mmc/zynq_sdhci.c index 9a1693940a..89776f48eb 100644 --- a/drivers/mmc/zynq_sdhci.c +++ b/drivers/mmc/zynq_sdhci.c @@ -776,6 +776,23 @@ static int arasan_sdhci_probe(struct udevice *dev) return ret; upriv->mmc = host->mmc;
+ /* + * Wait for 1000msec till the card detect state gets stable + * else host controller will set sd power bus voltage to 0. + */ + if (IS_ENABLED(CONFIG_ARCH_VERSAL)) { + u32 timeout = 1000; + + while (((sdhci_readl(host, SDHCI_PRESENT_STATE) & + SDHCI_CARD_STATE_STABLE) == 0) && timeout--) { + mdelay(1); + } + if (!timeout) { + dev_err(dev, "Sdhci card detect state not stable\n"); + return -ETIMEDOUT; + } + } + return sdhci_probe(dev); }