Sorry, Michal
I only wrote that part to explain how I was able to test on the ZC702 board (in case somebody else should want to reproduce the results).
I understand that you will sync the 'u-boot-xlnx' repo with mainline at some time in the future, on your own schedule. I was not trying to suggest that anything else be done right now.
Thanks again for your feedback,
Michael Burr // Software Engineer II
Logic PD T // 612.436.7273 NOTICE: Important disclaimers and limitations apply to this email. Please see this web page for our disclaimers and limitations: http://logicpd.com/email-disclaimer/
-----Original Message----- From: Michal Simek [mailto:monstr@monstr.eu] Sent: Tuesday, September 24, 2013 3:31 AM To: Michael Burr Cc: hs@denx.de; u-boot@lists.denx.de Subject: Re: [PATCH] i2c:zynq: I2C multi-bus support on Zynq
Tested: Xilinx ZC702 eval board (single bus master 'I2C0' with multiplexer PCA9548). Write and read registers with addresses of length 0 and 1.
Note: Mainline code does not work "out of the box" on ZC702 at this time; ad hoc adaptations based on 'u-boot-xlnx' repository were needed in order to test on this board. (Those adapatations are not included with this patch.)
? Where can I find this repository?
[MRB:] At the following address. (I believe Michal Simek is the person who manages this.)
That's xilinx repo. But you should remove this from commit message. If there is something wrong in the mainline u-boot initialization in connection to this you should send patch for it. As I wrote you in other email we are going to invest our time to sync configuration from this repo with mainline in the next merge window because also these changes when they are reviewed will go to the next u-boot version.
Thanks, Michal
-- Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91 w: www.monstr.eu p: +42-0-721842854 Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/ Maintainer of Linux kernel - Xilinx Zynq ARM architecture Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform