30 May
2014
30 May
'14
6:52 a.m.
On Thu, May 29, 2014 at 12:02 AM, Stefano Babic sbabic@denx.de wrote:
Hi Tim,
I cannot build with this version. A setup for a couple of pins is not yet replaces.
In fact, I have:
/* Enable Backlight */ imx_iomux_v3_setup_pad(MX6_PAD_SD1_CMD__GPIO1_IO18 |and it should be:
SETUP_IOMUX_PAD(PAD_SD1_CMD__GPIO1_IO18 |
The same some lines later:
/* Backlight CABEN on LVDS connector */
imx_iomux_v3_setup_pad(MX6_PAD_SD2_CLK__GPIO1_IO10 |
SETUP_IOMUX_PAD(PAD_SD2_CLK__GPIO1_IO10 |Can you check and fix it ? Thanks !
Regarding your patchset: I had no remarkable comments and, as I have not seen any comments from other developers, your patchset is ready to be merged. I am also waiting for Masahiro's patch to be applied.
Best regards, Stefano Babic
Stefano,
Those should be patched from patch 10. However, I can't seem to get patch 9 to apply cleanly from current u-boot-imx/master so perhaps I should just rebase the whole series and post again?
Tim