Adjust the Ethernet initialisation code to support driver model. It is no-longer necessary to call designware_initialize(). The device will be probed when it is used. The PHY type and GMAC base will come from the device tree.
Signed-off-by: Simon Glass sjg@chromium.org ---
Changes in v2: - Remove unwanted printf()
board/sunxi/gmac.c | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-)
diff --git a/board/sunxi/gmac.c b/board/sunxi/gmac.c index 8849132..1540633 100644 --- a/board/sunxi/gmac.c +++ b/board/sunxi/gmac.c @@ -80,11 +80,15 @@ int sunxi_gmac_initialize(bd_t *bis) sunxi_gpio_set_cfgpin(pin, SUN6I_GPA0_GMAC); #endif
-#ifdef CONFIG_RGMII +#ifdef CONFIG_DM_ETH + return 0; +#else +# ifdef CONFIG_RGMII return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_RGMII); -#elif defined CONFIG_GMII +# elif defined CONFIG_GMII return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_GMII); -#else +# else return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_MII); +# endif #endif }