Jean-Christophe PLAGNIOL-VILLARD wrote:
On 13:33 Thu 05 Jun , Hugo Villeneuve wrote:
ARM: This patch adds support for the Lyrtech SFF-SDR board, based on the TI DaVinci architecture (ARM926EJS).
Changes between V5 and V6: -New email address for contributor. -Init of EMIF-A CS3 address space to load FPGA. -Dynamic parsing of MAC address in EEPROM. -Add boot delay of 5 sec. -Use NFS for Linux boot command. -Add relocate flag for command history.
Signed-off-by: Hugo Villeneuve hugo.villeneuve@lyrtech.com Signed-off-by: Philip Balister, OpenSDR philip@opensdr.com
CREDITS | 5 +
- /* Set the Bus Priority Register to appropriate value */
- REG(VBPR) = 0x20; +
- timer_init();
- return(0);
+}
Is it possible that you add a documentiation about the EEPROM content?
Hi Jean-Christophe, unfortunately, I don´t have the data structure of the EEPROM, only the algorithym to parse it to find the MAC address.
+/*=======*/ +/* Board */ +/*=======*/
If Possible use this kind of comment style /*
*/
Ok, I fixed it.
+#define LINUX_BOOT_PARAM_ADDR 0x80000100 +#define CONFIG_CMDLINE_TAG +#define CONFIG_SETUP_MEMORY_TAGS +#define CONFIG_BOOTARGS \
- "mem=56M " \
- "console=ttyS0,115200n8 " \
- "root=/dev/nfs rw noinitrd ip=dhcp " \
- "nfsroot=${serverip}:/nfsroot/sffsdr " \
- "nwhwconf=device:eth0,hwaddr:${ethaddr}"
+#define CONFIG_BOOTCOMMAND \
- "nand read 87A00000 100000 300000;" \
- "bootelf 87A00000"
Could you align it or I will do it when I'll apply the patch, If it's ok with you.
Since I´m not sure how you want it to be aligned, please go ahead and do it when you apply the patch as you suggested.
I¬m sending updated patch after this mail.
Thank-you, Hugo V.
Hugo Villeneuve Hardware developer | Concepteur matériel Lyrtech Phone/Tél. : (1) (418) 877-4644 #2395 Toll-free/Sans frais - Canada & USA : (1) (888) 922-4644 #2395 Fax/Téléc. : (1) (418) 877-7710 www.lyrtech.com Infinite possibilities...TM