st 23. 2. 2022 v 15:02 odesÃlatel Michal Simek michal.simek@xilinx.com napsal:
From: Ashok Reddy Soma ashok.reddy.soma@xilinx.com
Based on discussion at https://lore.kernel.org/r/20200318125003.GA2727094@kroah.com we got recommendation to use explicit values for all enums.
So, add explicit values to all pinctrl related enums for readability.
Signed-off-by: Ashok Reddy Soma ashok.reddy.soma@xilinx.com Signed-off-by: Michal Simek michal.simek@xilinx.com
include/dm/pinctrl.h | 48 ++++++++++++++++++++++---------------------- 1 file changed, 24 insertions(+), 24 deletions(-)
diff --git a/include/dm/pinctrl.h b/include/dm/pinctrl.h index 8b869c4fbfb7..0c461e56bb48 100644 --- a/include/dm/pinctrl.h +++ b/include/dm/pinctrl.h @@ -453,30 +453,30 @@ struct pinctrl_ops {
presented using the packed format.*/ enum pin_config_param {
PIN_CONFIG_BIAS_BUS_HOLD,PIN_CONFIG_BIAS_DISABLE,PIN_CONFIG_BIAS_HIGH_IMPEDANCE,PIN_CONFIG_BIAS_PULL_DOWN,PIN_CONFIG_BIAS_PULL_PIN_DEFAULT,PIN_CONFIG_BIAS_PULL_UP,PIN_CONFIG_DRIVE_OPEN_DRAIN,PIN_CONFIG_DRIVE_OPEN_SOURCE,PIN_CONFIG_DRIVE_PUSH_PULL,PIN_CONFIG_DRIVE_STRENGTH,PIN_CONFIG_DRIVE_STRENGTH_UA,PIN_CONFIG_INPUT_DEBOUNCE,PIN_CONFIG_INPUT_ENABLE,PIN_CONFIG_INPUT_SCHMITT,PIN_CONFIG_INPUT_SCHMITT_ENABLE,PIN_CONFIG_LOW_POWER_MODE,PIN_CONFIG_OUTPUT_ENABLE,PIN_CONFIG_OUTPUT,PIN_CONFIG_POWER_SOURCE,PIN_CONFIG_SLEEP_HARDWARE_STATE,PIN_CONFIG_SLEW_RATE,PIN_CONFIG_SKEW_DELAY,PIN_CONFIG_END = 0x7F,PIN_CONFIG_MAX = 0xFF,
PIN_CONFIG_BIAS_BUS_HOLD = 0,PIN_CONFIG_BIAS_DISABLE = 1,PIN_CONFIG_BIAS_HIGH_IMPEDANCE = 2,PIN_CONFIG_BIAS_PULL_DOWN = 3,PIN_CONFIG_BIAS_PULL_PIN_DEFAULT = 4,PIN_CONFIG_BIAS_PULL_UP = 5,PIN_CONFIG_DRIVE_OPEN_DRAIN = 6,PIN_CONFIG_DRIVE_OPEN_SOURCE = 7,PIN_CONFIG_DRIVE_PUSH_PULL = 8,PIN_CONFIG_DRIVE_STRENGTH = 9,PIN_CONFIG_DRIVE_STRENGTH_UA = 10,PIN_CONFIG_INPUT_DEBOUNCE = 11,PIN_CONFIG_INPUT_ENABLE = 12,PIN_CONFIG_INPUT_SCHMITT = 13,PIN_CONFIG_INPUT_SCHMITT_ENABLE = 14,PIN_CONFIG_LOW_POWER_MODE = 15,PIN_CONFIG_OUTPUT_ENABLE = 16,PIN_CONFIG_OUTPUT = 17,PIN_CONFIG_POWER_SOURCE = 18,PIN_CONFIG_SLEEP_HARDWARE_STATE = 19,PIN_CONFIG_SLEW_RATE = 20,PIN_CONFIG_SKEW_DELAY = 21,PIN_CONFIG_END = 127, /* 0x7F */PIN_CONFIG_MAX = 255, /* 0xFF */};
#if CONFIG_IS_ENABLED(PINCTRL_GENERIC)
2.35.1
Applied. M