Re: [U-Boot] [PATCH 3/3 V3] Add board support for hawkboard

Hi Sughosh,

[...]

• hawkboard_nand_config - Used to generate the secondary

bootloader(nand_spl) image. This creates an elf file u-boot-spl under nand_spl/. Create an AIS signed image using this file, and flash it to the nand flash at address 0x20000. The ais file should fit in one block.

Could you elaborate on "create an AIS signed image" a little bit for people who are not intimately familiar with this architecture? Maybe you can add a small doc/README.da8xx for that purpose?

• hawkboard_uart_config - This is same as the first image, but with

the TEXT_BASE as expected by the RBL(0xc1080000). Create the AIS Signed bin, as use the normal UART boot procedure to boot the image.

Again a short step-by-step instruction in a readme file would be a very valuable addition.

Thanks Detlev