On 08:32 Thu 02 Jul , E Robertson wrote:
On Thursday 02 July 2009 02:22:16 am Frank Svendsbøe wrote:
On Thu, Jul 2, 2009 at 6:10 AM, E Robertsone.robertson.svg@gmail.com
wrote:
Hi All, Has anyone used the JTAG like the BDI2000 to load u-boot onto a at91sam9263? I've done it on other boards but some some reason the code will not execute from on board SDRAM. To avoid initializing the external memory via jtag, I use the bootstrap code to do the setup then load u-boot and run it. For reason(s) I haven't figured out yet, the code will not external memory. Has anyone done this before and can provide some help? Thanks.
How come you want to execute it from RAM? Is the board without flash? Could you instead replace the "bootstrap" loader with U-Boot?
It the SDRAM controller is already setup, I guess you must recode U-Boot and tell it not to touch/re-initialize the memory controller...
Btw, look at http://www.denx.de/wiki/view/DULG/CanUBootBeConfiguredSuchThatItCanBeStarte dInRAM
- Frank
In this case, I believe things are a bit different. U-boot is not relocated because the bootstrap already does this and the bootstrap does all the init needed to set up ram (among other things). I'm tracking a problem which is why I'm trying to run it from ram. I've done quite a bit of modifications to the point where I believe this should work, but apparently I may have overlooked something.
I do this for sometime on the 9263ek and it's work fine I use most of the time a peddi and I only need to disable the phy reset in the code and upload it in memory
Best Regards, J.