On Wed, Aug 20, 2014 at 01:29:57PM -0600, Stephen Warren wrote:
On 08/18/2014 02:00 AM, Thierry Reding wrote:
From: Thierry Reding treding@nvidia.com
RX and TX descriptor rings should be aligned to 256 byte boundaries. Use the DEFINE_ALIGN_BUFFER() macro to define the buffers so that they don't have to be manually aligned later on. Also make sure that the buffers do align to cache-line boundaries in case the cache-line is higher than the 256 byte alignment requirements of the NIC.
Also add a warning if the cache-line size is larger than the descriptor size, because the driver may discard changes to descriptors made by the hardware when requeuing RX buffers.
@@ -909,6 +899,18 @@ static int rtl_init(struct eth_device *dev, bd_t *bis)
- /*
* Warn if the cache-line size is larger than the descriptor size. In* such cases the driver will likely fail because the CPU needs to* flush the cache when requeuing RX buffers, therefore descriptors* written by the hardware may be discarded.*/- if (ARCH_DMA_MINALIGN > sizeof(struct RxDesc))
printf("WARNING: cache-line size is larger than descriptor size\n");I'd be tempted to make that a compile-time #error (or perhaps just a #warning) Perhaps #error would break compilation of existing boards though?
There are two SH4 boards that use the rtl8169 (r7780mp and sh7785lcr) for which this condition is true, so #error would break them (well, technically not r7780mp since it comments out CONFIG_RTL8169 in the configuration). I'll make it a #warning instead.
Thierry