Re: [U-Boot] Porting u-boot for MPC8280 based board.

Dear Thirumalesha N,

In message CAO1Rv-a_hPKfmm2ix_Gc0BgokiQk=qMOnUK4NOmuVxkQWXsn=g@mail.gmail.com you wrote:

...

...

I have BDI 2000 tool, but its not connecting to board.

This is a problem that should be fixable. Keep in mind that the MPC82xx can come up in different modes, depending on if there is a valid HRCW in flash or not. This can change the start address, too. Try both high and low boot configurations.

    For reset circuitry HRCW is there. In hardware also its considered.

if i Want to try for high boot have to change TEXT_BASE address?

In the first place, you must get the BDI working. To do so, you have to tweak the BDI config file.

Best regards,

Wolfgang Denk