On Fri, 2021-08-06 at 13:03 +0200, Stefano Babic wrote:
On 23.07.21 08:39, Oleksandr Suvorov wrote:
From: Marcel Ziswiler marcel.ziswiler@toradex.com
The USB recovery mode is used by Toradex to load the Toradex Easy Installer image which supports further system images installation. Prepare for loading and launching the Toradex Easy Installer if the USB Recovery mode is activated.
Signed-off-by: Marcel Ziswiler marcel.ziswiler@toradex.com Signed-off-by: Oleksandr Suvorov oleksandr.suvorov@toradex.com
Changes in v2:
- remove 2 patches not meet requirements.
END
board/toradex/apalis-tk1/apalis-tk1.c | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-)
diff --git a/board/toradex/apalis-tk1/apalis-tk1.c b/board/toradex/apalis-tk1/apalis-tk1.c index b97617cfca..f418f2c39f 100644 --- a/board/toradex/apalis-tk1/apalis-tk1.c +++ b/board/toradex/apalis-tk1/apalis-tk1.c @@ -38,8 +38,17 @@ int arch_misc_init(void) { if (readl(NV_PA_BASE_SRAM + NVBOOTINFOTABLE_BOOTTYPE) == - NVBOOTTYPE_RECOVERY) - printf("USB recovery mode\n"); + NVBOOTTYPE_RECOVERY) { + printf("USB recovery mode, attempting to boot Toradex Easy Installer\n"); + env_set("bootdelay", "-2"); + env_set("defargs", "pcie_aspm=off user_debug=30"); + env_set("fdt_high", ""); + env_set("initrd_high", ""); + env_set("setup", "env set setupargs igb_mac=${ethaddr} consoleblank=0 no_console_suspend=1 console=${console},${baudrate}n8 ${memargs}"); + env_set("teziargs", "rootfstype=squashfs root=/dev/ram quiet autoinstall"); + env_set("vidargs", "video=HDMI-A-1:640x480-16@60D"); + env_set("bootcmd", "run setup; env set bootargs ${defargs} ${setupargs} ${vidargs} ${teziargs}; bootm 0x80208000#config@${soc}-${fdt_module}-${fdt_board}.dtb");
These above are very long lines making checkpatch unhgappy. Can we switch to a multiline ?
Yes, I fully agree. I will pick it up and send a v3 shortly as Oleksandr unfortunately meanwhile left our company.
Best regards, Stefano
+ } /* PCB Version Indication: V1.2 and later have GPIO_PV0 wired to GND */ gpio_request(TEGRA_GPIO(V, 0), "PCB Version Indication");