=> usb start starting USB... Bus usb@fd800000: USB EHCI 1.00 scanning bus usb@fd800000 for devices... 4 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found => usb tree USB device tree: 1 Hub (480 Mb/s, 0mA) | u-boot EHCI Host Controller | +-2 Hub (480 Mb/s, 100mA) | USB 2.0 Hub | +-3 Mass Storage (480 Mb/s, 224mA) | SanDisk Dual Drive 04019c9b2e1a58f24ee318c3c123aa5 | +-4 Human Interface (12 Mb/s, 100mA) CX 2.4G Receiver
Co-developed-by: Manoj Sai abbaraju.manojsai@amarulasolutions.com Signed-off-by: Manoj Sai abbaraju.manojsai@amarulasolutions.com Signed-off-by: Jagan Teki jagan@amarulasolutions.com --- Changes for v3: - new patch
configs/radxa-cm3-io-rk3566_defconfig | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/configs/radxa-cm3-io-rk3566_defconfig b/configs/radxa-cm3-io-rk3566_defconfig index 10b81e0c6d..404ada3323 100644 --- a/configs/radxa-cm3-io-rk3566_defconfig +++ b/configs/radxa-cm3-io-rk3566_defconfig @@ -39,6 +39,7 @@ CONFIG_SPL_STACK_R=y CONFIG_SPL_ATF=y CONFIG_CMD_GPT=y CONFIG_CMD_MMC=y +CONFIG_CMD_USB=y # CONFIG_CMD_SETEXPR is not set # CONFIG_SPL_DOS_PARTITION is not set CONFIG_SPL_OF_CONTROL=y @@ -58,11 +59,15 @@ CONFIG_MMC_SDHCI_SDMA=y CONFIG_MMC_SDHCI_ROCKCHIP=y CONFIG_ETH_DESIGNWARE=y CONFIG_GMAC_ROCKCHIP=y +CONFIG_PHY_ROCKCHIP_INNO_USB2=y CONFIG_REGULATOR_PWM=y CONFIG_PWM_ROCKCHIP=y CONFIG_SPL_RAM=y CONFIG_BAUDRATE=1500000 CONFIG_DEBUG_UART_SHIFT=2 CONFIG_SYSRESET=y +CONFIG_USB=y +CONFIG_USB_EHCI_HCD=y +CONFIG_USB_EHCI_GENERIC=y # CONFIG_BINMAN_FDT is not set CONFIG_ERRNO_STR=y