These options only apply when not using DM_I2C. When using device trees, the dt will enable and control the speeds of the I2C controller(s) and these configuration options have no effect.
So disable them in DM_I2C mode. Otherwise they show up as decoys, and make it look like one is enabling I2C controllers and setting the speed when really it's doing nothing.
However, a system using a SPL build will not use DM_I2C in the SPL, even if DM_I2C is enabled for the main u-boot. And so the SPL might use the kconfig based I2C speed controls while the main u-boot does not.
Cc: Sriram Dash sriram.dash@nxp.com Cc: Priyanka Jain priyanka.jain@nxp.com Cc: Heiko Schocher hs@denx.de Signed-off-by: Trent Piepho tpiepho@impinj.com --- Changes from v1: Added patch in series to fix wandboard build issue Enable settings if SPL is enabled, as SPL will not use DM_I2C
drivers/i2c/Kconfig | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/i2c/Kconfig b/drivers/i2c/Kconfig index 215624020f..095a9bc6a4 100644 --- a/drivers/i2c/Kconfig +++ b/drivers/i2c/Kconfig @@ -161,7 +161,10 @@ config SYS_I2C_MXC channels and operating on standard mode up to 100 kbits/s and fast mode up to 400 kbits/s.
-if SYS_I2C_MXC +# These settings are not used with DM_I2C, however SPL doesn't use +# DM_I2C even if DM_I2C is enabled, and so might use these settings even +# when main u-boot does not! +if SYS_I2C_MXC && (!DM_I2C || SPL) config SYS_I2C_MXC_I2C1 bool "NXP MXC I2C1" help