v3:
- Rework printout to be added at the end as opposed to churn over three separate patches - Andrew
- Reword patch 006 to better explain the thinking behind new image type - Andrew
v2: - Added CONFIG_OPTEE_TZDRAM_BASE instead of #ifndef OPTEE_TZDRAM_BASE as an error. - Tom Rini
- Added Tested-by: Peng Fan peng.fan@nxp.com - as indicated
- Added better explanation text to patch 6/9 "tools: mkimage: add optee image type"
- Fixed some checkpatch warnings in optee.c
v1: This series adds a new OPTEE bootable image type to u-boot, which is directly bootable with the bootm command.
There is already a TEE image type but, in this case the TEE firmware is loaded into RAM, jumped into and then back out of. This image type is a directly bootable image as described here : http://mrvan.github.io/optee-imx6ul
Instead of reusing the Linux bootable image type instead a new image type is defined, which allows us to perform additional image verification, prior to handing off control via bootm.
OPTEE images get linked to a specific address at compile time and must be loaded to this address too. This series extends out mkimage with a new image type that allows the OPTEE binary link location to be validated against CONFIG_OPTEE_TZDRAM_BASE and CONFIG_OPTEE_TZDRAM_SIZE respectively prior to proceeding through the bootm phase.
Once applied you can generate a bootable OPTEE image like this
mkimage -A arm -T optee -C none -d ./out/arm-plat-imx/core/tee.bin uTee.optee
That image can then be booted directly by bootm. bootm will verify the header contents of the OPTEE binary against the DRAM area carved out in u-boot. If the defined DRAM area does not match the link address specified we refuse to boot.
Kever - I'd like to suggest that your OPTEE SPL image takes a different image type IH_TYPE_OPTEE_SPL ? to indicate the different behavior your image type has versus a directly bootable bootm image.
Bryan O'Donoghue (9): optee: Add lib entries for sharing OPTEE code across ports optee: Add CONFIG_OPTEE_TZDRAM_SIZE optee: Add CONFIG_OPTEE_TZDRAM_BASE optee: Add optee_image_get_entry_point() optee: Add optee_image_get_load_addr() tools: mkimage: add optee image type optee: Add optee_verify_bootm_image() optee: Add error printout bootm: optee: Add mechanism to validate an OPTEE image before boot
common/bootm.c | 11 ++++++++- common/image.c | 1 + include/image.h | 1 + include/tee/optee.h | 41 ++++++++++++++++++++++++++++++++ lib/Kconfig | 1 + lib/Makefile | 1 + lib/optee/Kconfig | 24 +++++++++++++++++++ lib/optee/Makefile | 7 ++++++ lib/optee/optee.c | 66 +++++++++++++++++++++++++++++++++++++++++++++++++++ tools/default_image.c | 25 ++++++++++++++----- 10 files changed, 171 insertions(+), 7 deletions(-) create mode 100644 lib/optee/Kconfig create mode 100644 lib/optee/Makefile create mode 100644 lib/optee/optee.c