Hi,
On Fri, Feb 28, 2020 at 1:47 AM Peter Geis pgwipeout@gmail.com wrote:
On Fri, Feb 14, 2020 at 9:47 AM Loic Devulder ldevulder@suse.com wrote:
This serie add support for roc-rk33239 board from Firefly/Libre Computer:
- add missing L2 cache entry in rk3328 dts
- add roc-rk3328-cc board support
With this we can successfully boot the board with mainline U-Boot and binary blob firmwares. Boot with ATF and TPL/SPL partially works: TPL works fine but SPL fails to find a bootable device.
I have tpl/spl fully enabled on this device privately. The SPL fails to find a boot device when booted from the sdcard. It successfully boots from emmc though. I believe this is due to the 3.3/1.8 mode switch.
Actually this is due to no power being supplied to the card.
The SD card's VCC is driven by a switched regulator, which is controlled by SDMMC0_PWREN, and is also pulled down externally. The enable line is active low. The bootrom does not touch the line, but the MMC driver in U-boot sets PWREN in the MMC controller, which I assume changes the state of SDMMC0_PWREN.
My solution was to simply mux the pin over to GPIO, instead of being controlled through the MMC controller, the latter being the default. The GPIO default state is input, and so the external pull-down works to keep the power enabled. This is done by creating spl_board_init() especially for this board, so essentially creating another target.
I suppose the other way to do it is to enable a bunch of stuff such as regulators and GPIO in SPL, and also do proper pinmuxing, i.e. not throwing away pinctrl properties in the SPL device tree.
My work also includes syncing the rk3328 device tree files from the Linux kernel, along with some cleanups. If Loic and Kever are OK with another series, I can send it out.
Regards ChenYu
Have you tested off emmc with your patch?
I didn't used the DTS from Linux kernel: USB2 fails in that case, this should be corrected but maybe later?
Note: sorry if this serie has been send twice, but I had issue with my email server...
Loic Devulder (2): rockchip: rk3328: dts: add L2 cache entry rockchip: rk3328: add roc-rk3328-cc support
arch/arm/dts/Makefile | 3 +- arch/arm/dts/rk3328-roc-cc-u-boot.dtsi | 16 ++ arch/arm/dts/rk3328-roc-cc.dts | 260 +++++++++++++++++++++++++ arch/arm/dts/rk3328.dtsi | 25 ++- arch/arm/mach-rockchip/rk3328/Kconfig | 1 - board/rockchip/evb_rk3328/MAINTAINERS | 6 + configs/roc-cc-rk3328_defconfig | 95 +++++++++ doc/README.rockchip | 9 +- 8 files changed, 408 insertions(+), 7 deletions(-) create mode 100644 arch/arm/dts/rk3328-roc-cc-u-boot.dtsi create mode 100644 arch/arm/dts/rk3328-roc-cc.dts create mode 100644 configs/roc-cc-rk3328_defconfig
-- 2.25.0