On Friday 21 December 2007, shami Allam wrote:
Thanks for the information. But I read some where that for the Lab testing purpose that I can give the IP address!!!!!
Please don't mix up ethernet address (== MAC address) and IP address. Of course you can set ip addresses (and should if you don't use dhcp/bootp). But you have to configure valid ethernet addresses too. If you don't have an ethernet address pool, you can use the "tools/gen_eth_addr" tool to create a random valid eth address for testing.
I am able to read the PHY inforamtion by command mii info 0x01<PHY Addr>. Following is the info.... => mii info 0x01 PHY_PHYIDR2 @ 0x1 = 0x5c90 PHY_PHYIDR[1,2] @ 0x1 = 0x20005c90 PHY_BMCR value is 0x2100 PHY 0x01: OUI = 0x80017, Model = 0x09, Rev = 0x00, 100baseT, FDX
And what does "mii info" show (without parameter)?
What is the value of CONFIG_PHY_ADDR in your board config file?
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================