This patch fixes following build warning
Invalid Kwbimage command Type - valid names are: BOOT_FROM, NAND_ECC_MODE, NAND_PAGE_SIZE, SATA_PIO_MODE, DDR_INIT_DELAY, DATA, , spi, nand, sata, pex, uart
Signed-off-by: Prafulla Wadaskar prafulla@marvell.com --- board/keymile/km_arm/kwbimage.cfg | 3 +-- 1 files changed, 1 insertions(+), 2 deletions(-)
diff --git a/board/keymile/km_arm/kwbimage.cfg b/board/keymile/km_arm/kwbimage.cfg index d6edd27..26d6aa0 100644 --- a/board/keymile/km_arm/kwbimage.cfg +++ b/board/keymile/km_arm/kwbimage.cfg @@ -64,7 +64,6 @@ DATA 0xFFD01400 0x43000400 # SDRAM Configuration Register # bit31-30: 01
DATA 0xFFD01404 0x36343000 # DDR Controller Control Low - 0x38543000 # bit 3-0: 0 reserved # bit 4: 0=addr/cmd in smame cycle # bit 5: 0=clk is driven during self refresh, we don't care for APX @@ -170,7 +169,7 @@ DATA 0xFFD0149C 0x0000E90F # CPU ODT Control # bit11-10:2, DQ_ODTSel. ODT select turned on, 75 ohm
DATA 0xFFD01480 0x00000001 # DDR Initialization Control -#bit0=1, enable DDR init upon this register write +# bit0=1, enable DDR init upon this register write
# End of Header extension DATA 0x0 0x0