Am 15.02.2020 um 15:02 schrieb Marek Vasut:
The default timer rate may be different than 25 MHz, permit overriding the default rate in board configuration file. Ultimatelly, this should be properly handled by a clock driver, however that is not available on Gen5 yet.
Sigh, yes, I still haven't found the time to fight those size problems I have... :-(
Signed-off-by: Marek Vasut marex@denx.de Cc: Ley Foon Tan ley.foon.tan@intel.com Cc: Simon Goldschmidt simon.k.r.goldschmidt@gmail.com
include/configs/socfpga_common.h | 2 ++ 1 file changed, 2 insertions(+)
diff --git a/include/configs/socfpga_common.h b/include/configs/socfpga_common.h index 8d10469e7c..8c5dcfa57c 100644 --- a/include/configs/socfpga_common.h +++ b/include/configs/socfpga_common.h @@ -98,8 +98,10 @@
Just above this line, there's this comment: "This timer uses eosc1, whose clock frequency is fixed at any condition".
While I'm ok with the change below, it does look a bit funny to make this overriable if it's "fixed at any condition". Could you elaborate on this? Do we need to change the comment?
Regards, Simon
#define CONFIG_SYS_TIMERBASE SOCFPGA_OSC1TIMER0_ADDRESS #define CONFIG_SYS_TIMER_COUNTS_DOWN #define CONFIG_SYS_TIMER_COUNTER (CONFIG_SYS_TIMERBASE + 0x4) +#ifndef CONFIG_SYS_TIMER_RATE #define CONFIG_SYS_TIMER_RATE 25000000 #endif +#endif
/*
- L4 Watchdog