8 Jun
2009
8 Jun
'09
9:04 a.m.
Dear alfred steele,
In message 528f13590906071928m77903d07x2d238a3c1dae4548@mail.gmail.com you wrote:
I have a requirement fro initializing the GPIO pin for interrupt on a custom FPGA on the MX31 board. Where should i add this code in the uboot tree.
It depends a bit on if there are special requirements about when this initialization must be done. If there are no special requirements, misc_init_r() is a good candidate.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
Nothing ever becomes real until it is experienced. - John Keats