31 Mar
2017
31 Mar
'17
10:13 p.m.
On 03/29/2017 07:21 AM, Ruchika Gupta wrote:
From: Vinitha Pillai-B57223 vinitha.pillai@nxp.com
- Add SD secure boot target for ls1046ardb.
- Implement board specific spl_board_init() to setup CAAM stream ID and corresponding stream ID in SMMU.
- Change the u-boot size defined by a macro for copying the main U-Boot by SPL to also include the u-boot Secure Boot header size as header is appended to u-boot image. So header will also be copied from SD to DDR.
- CONFIG_MAX_SPL_SIZE is limited to 90K.SPL is copied to OCRAM (128K) where 32K are reserved for use by boot ROM and 6K for the header
- Reduce the size of CAAM driver for SPL. Since the size of spl image was about 94K, Blobification functions and descriptors, that are not required at the time of SPL are disabled. Further error code conversion to strings is disabled for SPL build. This reduces the spl image size to 92K.
Signed-off-by: Vinitha Pillai vinitha.pillai@nxp.com Signed-off-by: Sumit Garg sumit.garg@nxp.com Signed-off-by: Ruchika Gupta ruchika.gupta@nxp.com
Changes from v1:
- Rebased patches to latest dependent patch set
- With the dependent path set , spl imag size increased to 94K. So
- additionally reduce the spl image size by removing the functions from
- CAAM driver that are not required in SPL flow
<snip>
+#if defined(CONFIG_SPL_BUILD) +void spl_board_init(void) +{ +#ifdef CONFIG_SECURE_BOOT
- /*
* In case of Secure Boot, the IBR configures the SMMU* to allow only Secure transactions.* SMMU must be reset in bypass mode.* Set the ClientPD bit and Clear the USFCFG Bit- */
- u32 val;
- val = (in_le32(SMMU_SCR0) | SCR0_CLIENTPD_MASK) & ~(SCR0_USFCFG_MASK);
- out_le32(SMMU_SCR0, val);
- val = (in_le32(SMMU_NSCR0) | SCR0_CLIENTPD_MASK) & ~(SCR0_USFCFG_MASK);
- out_le32(SMMU_NSCR0, val);
+#endif +}
Is this the same as LS1043A? Can we move this function to arch/arm/cpu/armv8/fsl-layerscape/spl.c?
York