Hi Kurt,
I've just applied your patch to add Spartan III support on my custom hardware (PPChameleon AMCC405EP). To write the board-specific functions I used the file board/gen860t/fpga.c as starting point. I work with cross GCC 2.95.4 provided by ELDK 2.0.2. The programming technique is slave serial. To make the code to work I had to apply some slight changes:
1) In function Spartan3_ss_load I had to replace this line
(*fn->wr) ((val < 0), TRUE, cookie);
with if (val & 0x80) { (*fn->wr) (1, TRUE, cookie); } else { (*fn->wr) (0, TRUE, cookie); }
It seems the compiler does not like the expression (val < 0) because it is always evaluated to 0.
2) It seems the board-specific function fpga_done_fn in board/gen860t/fpga.c is wrong because it returns the error codes (either FPGA_SUCCESS or FPGA_FAIL). In my understanding it must return the state of the pin (0 when the DONE pin is low, 1 when it is high).
3) I tried to use both the "fpga load" and "fpga loadb" commands respectively with the .bin and .bit files. The first one runs succesfully while the latter fails. In this case the header is parsed correctly but the FPGA is not programmed and the DONE does not go high.
Best regards, llandre
DAVE Electronics System House - R&D Department web: http://www.dave-tech.it email: r&d2@dave-tech.it
Hi all.
This small patch, against current cvs, adds Xilinx Spartan3 support. Only the bitstream size differs from the Spartan2 family, the configuration method stays the same.
Regards Kurt
CHANGELOG:
- Patch by Kurt Stremerch, 14 February 2005: Add Xilinx Spartan3 family fpga support