Dear Vipin Kumar,
In message 83d1d72b0912182302m68e7ba06q5e23a695f85534f@mail.gmail.com you wrote:
--- a/common/main.c +++ b/common/main.c @@ -397,6 +397,7 @@ void main_loop (void)
debug ("### main_loop: bootcmd=\"%s\"\n", s ? s : "<UNDEFI> NED>");+#if !defined(CONFIG_SPEAR_USBTTY) if (bootdelay >= 0 && s && !abortboot (bootdelay)) { # ifdef CONFIG_AUTOBOOT_KEYED int prev = disable_ctrlc(1); /* dis> able Control C checking */ @@ -413,6 +414,7 @@ void main_loop (void) disable_ctrlc(prev); /* restore Contr> ol C checking */ # endif } +# endif
Why would this be needed?
We also use u-boot as a firmware which runs on the board in a special mode in which the firmware fetches and burns images into NOR/NAND flashes. Under this mode, we would like to always jump to u-boot prompt.
This can be done by plain config settings. No need to chang ethe code.
Also, the bootdelay variable should remain unchanged as we save default environment variables as well.
Think of a different way to switch modes, please. I don't accept this change to common code.
Too long lines.
I assume line length of 80 is acceptable. Right?
Maximum, right.
Best regards,
Wolfgang Denk