-----Original Message----- From: u-boot-bounces@lists.denx.de [mailto:u-boot-bounces@lists.denx.de] On Behalf Of Albert Aribaud Sent: Friday, July 09, 2010 12:11 AM To: u-boot@lists.denx.de Subject: [U-Boot] [PATCH V3 4/4] edminiv2: add cmd_ide support
This patch uses mv_sata_ide and cmd_ide to enable the use of the integrated SATAHC controller port 1.
Signed-off-by: Albert Aribaud albert.aribaud@free.fr
board/LaCie/edminiv2/edminiv2.c | 5 ++++ include/configs/edminiv2.h | 47 +++++++++++++++++++++++++++++++++++++- 2 files changed, 50 insertions(+), 2 deletions(-)
diff --git a/board/LaCie/edminiv2/edminiv2.c b/board/LaCie/edminiv2/edminiv2.c index 54c0ffe..6336429 100644 --- a/board/LaCie/edminiv2/edminiv2.c +++ b/board/LaCie/edminiv2/edminiv2.c @@ -88,5 +88,10 @@ int board_init(void) /* boot parameter start at 256th byte of RAM base */ gd->bd->bi_boot_params = gd->bd->bi_dram[0].start + 0x100;
- /* Enable SATA ports if SATA IDE was configured */
+#if defined(CONFIG_MV_SATA_IDE)
- mv_sata_ide_initialize_port(orion5x_port1_sata_registers);
+#endif
- return 0;
} diff --git a/include/configs/edminiv2.h b/include/configs/edminiv2.h index c3d95a0..1a61437 100644 --- a/include/configs/edminiv2.h +++ b/include/configs/edminiv2.h @@ -52,6 +52,12 @@ #define CONFIG_SYS_HZ 1000
/*
- __io is necessary for cmd_ide to compile
- */
+#define __io
+/*
- Board-specific values for Orion5x MPP low level init:
- MPPs 12 to 15 are SATA LEDs (mode 5)
- Others are GPIO/unused (mode 3 for MPP0, mode 5 for
@@ -60,7 +66,7 @@
#define ORION5X_MPP0_7 0x00000003 #define ORION5X_MPP8_15 0x55550000 -#define ORION5X_MPP16_23 0x00000000 +#define ORION5X_MPP16_23 0x00005555
/*
- Board-specific values for Orion5x GPIO low level init:
@@ -74,7 +80,6 @@ */
#define ORION5X_GPIO_OUT_ENABLE 0x03fcffff -#define ORION5X_GPIO_OUT_VALUE 0x03fcffff
Why did you removed this?
Regards.. Prafulla . .