In case the PHY is fully described in DT, use PHY MDIO address from DT directly instead of always using auto-detection. This also fixes the behavior of 'mdio list' in such DT setup, which now prints the PHY connected to the MAC correctly.
Signed-off-by: Marek Vasut marek.vasut+renesas@mailbox.org --- Cc: Joe Hershberger joe.hershberger@ni.com Cc: Paul Barker paul.barker.ct@bp.renesas.com Cc: Ramon Fried rfried.dev@gmail.com --- drivers/net/sh_eth.c | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/net/sh_eth.c b/drivers/net/sh_eth.c index 7b1f59dc498..5e2e3054ecf 100644 --- a/drivers/net/sh_eth.c +++ b/drivers/net/sh_eth.c @@ -12,6 +12,7 @@ #include <common.h> #include <cpu_func.h> #include <env.h> +#include <eth_phy.h> #include <log.h> #include <malloc.h> #include <net.h> @@ -597,11 +598,16 @@ static int sh_eth_phy_config(struct udevice *dev) struct sh_ether_priv *priv = dev_get_priv(dev); struct eth_pdata *pdata = dev_get_plat(dev); struct sh_eth_dev *eth = &priv->shdev; - int ret = 0; struct sh_eth_info *port_info = ð->port_info[eth->port]; struct phy_device *phydev; + int phy_addr; + int ret = 0; + + phy_addr = eth_phy_get_addr(dev); + if (phy_addr < 0) + phy_addr = -1;
- phydev = phy_connect(priv->bus, -1, dev, pdata->phy_interface); + phydev = phy_connect(priv->bus, phy_addr, dev, pdata->phy_interface); if (!phydev) return -ENODEV;