Move this board over to driver model for MMC and SATA. This means that it uses CONFIG_BLK as well. In SPL these options remain turned off since it increases the code size. One option would be to use CONFIG_SPL_OF_PLATDATA to avoid device-tree overhead.
Signed-off-by: Simon Glass sjg@chromium.org ---
arch/arm/dts/sun7i-a20-pcduino3.dts | 1 - configs/Linksprite_pcDuino3_defconfig | 7 ++++++- 2 files changed, 6 insertions(+), 2 deletions(-)
diff --git a/arch/arm/dts/sun7i-a20-pcduino3.dts b/arch/arm/dts/sun7i-a20-pcduino3.dts index 1a8b39be1d..d487c84562 100644 --- a/arch/arm/dts/sun7i-a20-pcduino3.dts +++ b/arch/arm/dts/sun7i-a20-pcduino3.dts @@ -164,7 +164,6 @@ pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_reference_design>; vmmc-supply = <®_vcc3v3>; bus-width = <4>; - cd-gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>; /* PH1 */ cd-inverted; status = "okay"; }; diff --git a/configs/Linksprite_pcDuino3_defconfig b/configs/Linksprite_pcDuino3_defconfig index 6f4a02f8d4..f0d382c002 100644 --- a/configs/Linksprite_pcDuino3_defconfig +++ b/configs/Linksprite_pcDuino3_defconfig @@ -15,7 +15,12 @@ CONFIG_SPL_I2C_SUPPORT=y # CONFIG_SPL_DOS_PARTITION is not set # CONFIG_SPL_ISO_PARTITION is not set # CONFIG_SPL_EFI_PARTITION is not set -CONFIG_SCSI=y +# CONFIG_SPL_BLK is not set +CONFIG_DM_MMC=y +# CONFIG_SPL_DM_MMC is not set +# CONFIG_SPL_DM_MMC_OPS is not set CONFIG_ETH_DESIGNWARE=y CONFIG_SUN7I_GMAC=y +CONFIG_SCSI=y +CONFIG_DM_SCSI=y CONFIG_USB_EHCI_HCD=y