From: Fabio Estevam fabio.estevam@freescale.com
mx6cuboxi sometimes fails to recognize the Ethernet PHY:
Net: Phy 0 not found
The explanation comes from a patch from Rabeeh:
"The LED_ACT pin on the carrier-one boards had a pull down that forces the phy address to 0x0; where on CuBox-i and the production HummingBoard that pin is connected directly to LED that depending on the pull down strength of the LED it might be sampled as '0' or '1' thus the phy address might appear as either address 0x0 or 0x4."
So fix this problem by telling phy_find_by_mask() to scan the PHY at addresses 0x0 and 0x4.
Reported-by: Vagrant Cascadian vagrant@aikidev.net Signed-off-by: Rabeeh Khoury rabeeh@solid-run.com Signed-off-by: Fabio Estevam fabio.estevam@freescale.com --- board/solidrun/mx6cuboxi/mx6cuboxi.c | 31 ++++++++++++++++++++++++++++++- 1 file changed, 30 insertions(+), 1 deletion(-)
diff --git a/board/solidrun/mx6cuboxi/mx6cuboxi.c b/board/solidrun/mx6cuboxi/mx6cuboxi.c index 9aa0259..ff018e1 100644 --- a/board/solidrun/mx6cuboxi/mx6cuboxi.c +++ b/board/solidrun/mx6cuboxi/mx6cuboxi.c @@ -25,6 +25,7 @@ #include <asm/imx-common/video.h> #include <mmc.h> #include <fsl_esdhc.h> +#include <malloc.h> #include <miiphy.h> #include <netdev.h> #include <asm/arch/crm_regs.h> @@ -152,9 +153,14 @@ int board_phy_config(struct phy_device *phydev) return 0; }
+/* On Cuboxi Ethernet PHY can be located at addresses 0x0 or 0x4 */ +#define ETH_PHY_MASK ((1 << 0x0) | (1 << 0x4)) + int board_eth_init(bd_t *bis) { struct iomuxc *const iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR; + struct mii_dev *bus; + struct phy_device *phydev;
int ret = enable_fec_anatop_clock(ENET_25MHZ); if (ret) @@ -165,7 +171,30 @@ int board_eth_init(bd_t *bis)
setup_iomux_enet();
- return cpu_eth_init(bis); + bus = fec_get_miibus(IMX_FEC_BASE, -1); + if (!bus) + return -EINVAL; + + phydev = phy_find_by_mask(bus, ETH_PHY_MASK, PHY_INTERFACE_MODE_RGMII); + if (!phydev) { + ret = -EINVAL; + goto free_bus; + } + + debug("using phy at address %d\n", phydev->addr); + ret = fec_probe(bis, -1, IMX_FEC_BASE, bus, phydev); + if (ret) { + printf("FEC MXC: %s:failed\n", __func__); + goto free_phydev; + } + + return 0; + +free_phydev: + free(phydev); +free_bus: + free(bus); + return ret; }
#ifdef CONFIG_VIDEO_IPUV3